Product features
• Using legacy analog 2 wire cabling for IP intercom connection including PoE power supply
• Long range Ethernet extension over 2 wires or coax
• Easy configuration, no IP address and network setup required, plug&play
Includes – what should you get with the delivery
• 2-piece converter units with Coax / 2 wire adapter• 1-piece power supply adapter
Product use
• Install 2N® 2Wire master unit where your ethernet cable ends and 2-cable wiring begins.• Plug in Ethernet and 2 cable wiring into the master unit..
• Install 2N® 2Wire slave unit where you need convert 2-cable wiring back to Ethernet at remote location. Please observe polarity of the 2 wires.
• Connect provided power supply to master unit.
• Any of the units can be master or slave. Master unit is the one with connected power supply while slave is powered via 2 wires.
• Blue Power LED indicators should indicate that both units are powered.
• Both BNC and PoE green LED should be blinking, thus signalling the established connection and data transmission.
Specification
• Speed : 10/100 Base T, half/full duplex, auto-negotiation
• IEEE 802.3 af/at 40Watt Compliant PoE+
• Cable Type : 2Wire, Cat 5e., Cat 6. or Similar
• Impedance : 25Ω to 100Ω
• Transmit Coverage : Typical 720ft (220m) @ Cat6 with PoE at far end; up to 2460ft (750m) possible; depends on wiring and interference
LED Indicators
• Power : Blue – Power ON
• BNC : Green – Link ON
• PoE : Green – Link ON
2N® 2Wire Joining procedure
In case you are using more than one pair of 2N 2Wire on one electical phase you need to do a joining procedure on each pair of 2Wire so they are communicating with correct end unit.
Before you start the joining procedure you need to have the 2 units of 2Wire connected together and do the Unjoining procedure (to be sure that the units are not communicating with another unit at the moment). The Unjoining procedure is described below.
Pick one of the units and put something small (a pencil end or a paper clip) and press a button inside PoE LED diode for 2 seconds. When you let the button go the PoE LED diode will start blinking, telling you that it is in a search mode.
Pick up the other unit and repeat the procedure. When you let go of the button behind the LED diode of PoE both units will start to blink.
After both units stop blinking, the Power and BNC LED diodes will be shining telling you, that both units are paired together.
2N® 2Wire Unjoining procedure
In case you want to unjoin two units so they can work with a different unit, pick the unit up and insert something small (a pencil end or a paper clip) into the PoE LED diode and press the small button behind the LED diode. Press the button for 10 seconds until the BNC diode stops shining.
Repeat the procedure also on the other unit.
Connection of more than 1 slave unit to 1 master unit
You can connect up to 4 slave units to each master unit. The interconnection can be done 2 ways:
1. Use coaxial cables and a splitter for coaxial cable
2. Use 4 pairs of 2 wire cable and connect them to terminal block that is delivered together with the unit. You can connect all 4 cables of each pair to corresponding terminal.
If you are using more than one slave unit connected to a master unit we recommend to use power supply also on the side of the slave unit to guarantee best performance.